How to use your DTF UV stickers.

Step 1: Cut out your design
Use scissors to cut out the sticker you want to apply, since all designs come together on one sheet.
Cut carefully around the design, or leave a small border if preferred.

Step 2: Make sure the surface is clean and dry
Before applying, clean the surface well.
It must be dry and free of dust, oil, or moisture so the adhesive can stick properly.

Step 3: Peel off the backing
Carefully remove the back layer, making sure the design stays attached to the clear transfer film.

Step 4: Place it on the surface
Position the sticker where you want it before pressing it down completely.
Once aligned, press it gently into place.

Step 5: Press firmly
Rub firmly over the entire design using your fingers or a card/plastic scraper to help it adhere well, especially around the edges.

Step 6: Remove the clear top film
Slowly peel off the clear top film.
Do this gently and at a soft angle.
If any part of the design lifts, press and rub again before continuing.

Step 7: Let it set
For best results, avoid water or heavy handling during the first few hours after application.

Recommendations

  • Apply only to smooth, clean, dry surfaces.

  • Works best on surfaces such as: glass, plastic, metal, acrylic, notebooks, laptops, tablets, phone cases, and rigid packaging.

  • Not recommended for highly textured or porous surfaces.

  • Avoid washing or scratching the area immediately after application.

Instrucciones de uso — Stickers DTF UV

Paso 1: Recorta el diseño
Usa tijeras para recortar el sticker que deseas aplicar, ya que todos vienen juntos en una sola lámina.
Recorta con cuidado siguiendo el contorno o dejando un pequeño borde si lo prefieres.

Paso 2: Asegúrate de que la superficie esté limpia y seca
Antes de aplicar el sticker, limpia bien la superficie.
Debe estar seca, libre de polvo, grasa o humedad para que el adhesivo pegue correctamente.

Paso 3: Retira el protector posterior
Despega con cuidado la parte trasera del sticker, asegurándote de que el diseño quede adherido a la película transparente.

Paso 4: Colócalo sobre la superficie
Ubica el sticker en el lugar deseado antes de presionar por completo.
Una vez colocado, presiónalo suavemente.

Paso 5: Presiona firmemente
Frota bien con los dedos o con una tarjeta/plástico rígido sobre toda la superficie del diseño para asegurarte de que se adhiera correctamente, especialmente en los bordes.

Paso 6: Retira la película transparente
Despega lentamente la película transparente superior.
Hazlo con cuidado y en un ángulo suave.
Si alguna parte del diseño se levanta, vuelve a presionar y frota un poco más antes de seguir retirando.

Paso 7: Déjalo fijar
Para mejores resultados, evita mojar o manipular demasiado el sticker durante las primeras horas después de aplicarlo.

Recomendaciones

  • Aplícalo sobre superficies lisas, limpias y secas.

  • Funciona mejor en objetos como: vidrio, plástico, metal, acrílico, libretas, laptops, tablets, fundas y empaques rígidos.

  • No se recomienda aplicar sobre superficies con mucha textura o porosas.

  • Evita lavar o raspar el área inmediatamente después de colocarlo.